Displaying posts in the categoryTutorials
Tutorials articles
Tutorials
The timing path report is the report every digital engineer meets first, and the one most people read backwards. They jump to the last line, see a slack number, and start fixing. A senior reads it top to bottom, because the header and the clock lines decide whether the slack at the bottom means anything. This is Part 2 of Reading Real Reports. Yesterday we covered the five questions to ask before opening any report. Today we take one setup pat…
by
The Semiconductor Hub
November 20, 2026
Tutorials
Most engineers learn to read a timing or synthesis report by being handed one and told to fix the worst path. Nobody explains that a senior engineer usually does not start with the worst path at all. The first few minutes go to a different question: can this report be trusted? A clean report from the wrong run, the wrong corner or the wrong constraints is worse than a failing one, because it ends the conversation early. This is Part 1 of Readi…
by
The Semiconductor Hub
November 19, 2026
Tutorials
Automotive electronics work as one control loop: sensors measure what is happening in and around the car, microcontrollers and processors decide what to do, vehicle networks carry the data and commands, and actuators and power electronics carry out the decision. In an electric vehicle the same electronics also convert and manage the energy that moves the car. No single part is useful on its own; reliability comes from designing the whole chain t…
by
The Editor's Desk
October 26, 2026
Tutorials
An optical power meter measures how much light arrives at a point in a fibre link, using a photodiode that turns optical power into an electrical current, and shows the result in watts or dBm. Paired with a stable light source it also measures optical loss in dB, which is how installers prove a link is within its budget. Accurate results depend on setting the right wavelength, using clean connectors, choosing the correct reference method and usi…
by
The Editor's Desk
October 26, 2026
Tutorials
Choosing a BGA package changes far more than the footprint. The package type, ball pitch, body size and thermal design decide how many PCB layers you need, whether the board needs HDI microvias, how tight the assembly window is, how solder joints are inspected and how long they survive thermal cycling. That is why BGA selection should be reviewed by design, PCB fabrication and assembly teams together, not left as a schematic-level decision. Ba…
by
The Editor's Desk
May 04, 2026
Tutorials
An ASIC (application-specific integrated circuit) and an SoC (system on chip) go through the same broad design flow, from specification to production, but an SoC takes roughly twice as long. In the infographic below, a focused ASIC runs about 12 to 24 months from specification to production, while a large SoC runs about 24 to 48 months. The extra time comes from integration: an SoC combines CPUs, GPUs, memory, licensed IP and software, and every…
by
Murugavel Ganesan
March 04, 2026
Tutorials
Updated 2026 CoWoS or EMIB? If your product is bound by HBM bandwidth and needs many memory stacks next to one or two very large logic dies, TSMC's CoWoS family (today mostly CoWoS-L) is still the lowest-risk choice. If you are building a portfolio of chiplet products, need very large packages at a controlled cost, or want to mix dies from different nodes and sources, Intel's EMIB and the newer EMIB-T are increasingly strong options. T…
by
Murugavel Ganesan
November 19, 2025