Just a day after our post on a standard phone charger, the unexpected happened: the universal phone charger became a reality (The Inquirer, February 2009, archived copy).
This is a dated record of that February 2009 news, with a short explanation of the technology behind it and what happened in the years after.
The 2009 announcement
On February 17, 2009, at Mobile World Congress in Barcelona, the GSM Association (GSMA) and 17 mobile operators and handset makers announced a common way to charge mobile phones. According to Electronic Design's report of the announcement, the group included 3 Group, AT&T, LG, Motorola, Nokia, Samsung, Sony Ericsson and Vodafone. They chose Micro-USB as the common charging connector and set a target that by January 1, 2012, most new phone models would support it and most chargers shipped would meet high efficiency targets set by the Open Mobile Terminal Platform (OMTP).
The Register covered the same announcement the same day.
Why it mattered
In 2009, almost every phone maker had its own charger plug, and often more than one. A new phone meant a new charger, the old one went in a drawer or a bin, and a borrowed charger rarely fitted. A shared connector meant:
- one charger could serve many phones, so buyers would not need a new one with every handset;
- fewer chargers would be made and thrown away;
- chargers built to an efficiency target would waste less power, including when left plugged in with no phone attached.
The group's own estimates, as reported by Electronic Design, were a 50 percent cut in standby energy use and up to 51,000 tons of duplicate chargers no longer made.
How a USB charger tells the phone what it can supply
Micro-USB carries 5 V on its power pin, plus two data lines, D+ and D-. A plain computer USB port is only required to supply a modest current, so a phone needs a way to know when it is plugged into a wall charger that can give more. The answer that became standard is simple: a dedicated charger connects the two data lines to each other. The phone sees the short, knows there is no computer on the other end, and draws a higher charging current. This is defined in the USB Battery Charging specification, revision 1.2 (BC1.2).
Deep dive: the numbers and details
This part holds the figures, port types and a worked example. Skip it if the overview is all you need.
USB charging port types under BC1.2
The table follows the description in TI's TPS2546-Q1 datasheet, section 8.3, which implements these modes.
| Port type | Data | Current | How the phone recognizes it |
|---|---|---|---|
| SDP (Standard Downstream Port) | Yes | At least 500 mA (USB 2.0), 900 mA (USB 3.0) | Normal USB enumeration |
| CDP (Charging Downstream Port) | Yes | At least 1.5 A | Host-charge handshake on D+ and D- |
| DCP (Dedicated Charging Port) | No | Up to 1.5 A | D+ and D- shorted through at most 200 ohms |
Worked example: charge time and power
Take a 1,500 mAh phone battery as an example and ignore the slower top-off phase at the end of charging.
- On a 500 mA SDP: 1,500 mAh / 500 mA = 3 hours, at 5 V x 0.5 A = 2.5 W.
- On a 1.5 A DCP: 1,500 mAh / 1,500 mA = 1 hour, at 5 V x 1.5 A = 7.5 W.
Real charge times are longer because the charger in the phone tapers the current as the battery nears full and loses some energy as heat, but the ratio shows why detecting a dedicated charger mattered.
Why standby power was a target
A charger left in the wall with nothing attached still draws a little power. Multiply a fraction of a watt by hundreds of millions of chargers, plugged in around the clock, and the total becomes significant. That is why the 2009 plan tied the common connector to an efficiency target rather than to the plug alone.
What happened next
The European Union later went further and made a common connector law. Under Directive (EU) 2022/2380, as the European Commission announced on December 28, 2024, USB-C became the required charging port from that date for phones, tablets, digital cameras, headphones and headsets, video game consoles, portable speakers, e-readers, keyboards, mice, portable navigation systems and earbuds sold in the EU, with laptops following from April 28, 2026. Devices may also be sold without a charger in the box. The Commission estimates the rules save consumers about 250 million euros a year on unneeded chargers, and that discarded and unused chargers account for about 11,000 tonnes of e-waste a year.
So the idea announced in 2009, one plug for every phone, ended up as law fifteen years later, with a newer connector.
Further reading
- Our earlier post on a standard phone charger (2009).
- Electronic Design: Mobile industry unites to drive universal charging solution.
- European Commission: EU common charger rules (December 2024).


Universal phone charger approved -->> micro-USB port -->>http://madhukaudantha.blogspot.com/2009/10/universal-phone-charger-approved.html
ReplyDelete