TDEB Top Bar

Trending
Semiconductor Industry News — The Digital Electronics Blog
Follow Us

TDEB Masthead

The Semiconductor Hub

Semiconductors.  Chips and Systems.  Innovation.

Indexed by leading Search Engines, AI and referenced by Engineers worldwide 500+ Articles 10M+ Pageviews 30+ Reports 50+ Citations

20 Cell Phones with the Highest Radiation Levels (2010)

mg
by
0
Share Facebook X LinkedIn WhatsApp Email

News item, first published March 18, 2010. The list and figures below are as reported at the time.

Cell phone radiation. Some consider it a health hazard of paramount importance. Others couldn't care less. Whichever camp you're in, there's some perverse satisfaction in clicking through CNET's countdown to see which is the most mind-melting gadget on the market.

What the CNET list showed

CNET's gallery, 20 cell phones with highest radiation levels, by David Carnoy and dated March 16, 2010, ranked phones then on the US market by their reported SAR value, from the lowest of the twenty up to the highest. The countdown opened with the T-Mobile Dash 3G at 1.47 W/kg, tied with the next three phones, and ended with the No. 1 phone, the Motorola V195, a basic flip phone, at 1.6 W/kg. The original page is gone; the link above goes to the Internet Archive copy from March 22, 2010.

Note that every phone on the list was legal to sell. The top value of 1.6 W/kg is exactly the US limit, so the list was really a ranking of phones that came closest to the limit, not of phones that broke it.

What SAR means, in plain words

A phone is a small radio transmitter held against your head. Some of the radio energy it sends out is absorbed by the body and turned into a tiny amount of heat. The specific absorption rate (SAR) measures how much: watts of radio power absorbed per kilogram of tissue. Regulators set a maximum SAR, and a phone must be tested and stay below it before it can be sold.

A higher SAR on such a list does not mean one phone is dangerous and another safe. All of them were under the same limit, and the figure comes from a standardized laboratory test, not from how a particular person uses the phone. In daily use a phone adjusts its transmit power to the signal; with good coverage it sends far less than the maximum.

Why it matters to engineers

For handset designers, SAR is a hard compliance target that shapes antenna placement, maximum transmit power and even the industrial design. A phone that fails SAR testing cannot ship, so antenna and RF teams budget for it from the start.

Deep dive: the numbers and details

This part holds the limits, the definition and a worked example. Skip it if the overview is all you need.

The limits

RuleLocal (head and body) limit for the general publicAveraging massWhole-body limit
United States, 47 CFR 1.1310(c)1.6 W/kgAny 1 g of tissue (cube)0.08 W/kg
ICNIRP 2020 guidelines, Table 2 (100 kHz to 6 GHz)2 W/kg10 g cube, over 6 minutes0.08 W/kg, over 30 minutes

The US rule also allows 4 W/kg over 10 g for the extremities (hands, wrists, feet, ankles and outer ears). Because the US averages over 1 g and ICNIRP over 10 g, the two numbers are not directly comparable: averaging over a smaller mass captures a sharper local peak, so a phone's 1 g figure is usually higher than its 10 g figure.

The definition

Locally, SAR = σ × E² / ρ, where σ is the tissue's electrical conductivity (S/m), E the rms electric field inside the tissue (V/m) and ρ the tissue density (kg/m³). Compliance labs measure E with a small probe moved through a tissue-simulating liquid inside a head-shaped or flat phantom, with the phone transmitting at full power, and then average over the required cube of tissue.

Worked example

At the US limit, 1.6 W/kg over 1 g means at most 1.6 mW absorbed in any 1 g cube of tissue. At the ICNIRP limit, 2 W/kg over 10 g means at most 20 mW in any 10 g cube. For comparison, the whole-body limit of 0.08 W/kg corresponds to about 5.6 W for a 70 kg adult averaged over the whole body. A handset's absorbed energy is concentrated in a small volume next to the antenna, which is why local, not whole-body, SAR is the limit that matters for phones.

Turning the definition around: with an illustrative conductivity of 0.9 S/m and density of 1,000 kg/m³, a local SAR of 1.6 W/kg needs an internal field of √(1.6 × 1,000 / 0.9) ≈ 42 V/m (rms).

Common misunderstandings

  • "Low SAR means low exposure in real use." The rating is a worst-case test at full power. Signal strength, distance from the body and use of a headset change real exposure far more than the difference between 1.2 and 1.5 W/kg.
  • "This is ionizing radiation." Phone signals are non-ionizing radio waves; the limits are set to keep tissue heating well below levels known to cause harm.
  • "US and European figures are the same thing." They use different averaging masses, so compare like with like.

What happened next

  • CNET kept updating the gallery. By its November 30, 2010 version, the top spot went to the Sony Ericsson Satio (Idou) at 1.56 W/kg (Internet Archive copy).
  • On May 31, 2011, the World Health Organization's International Agency for Research on Cancer classified radiofrequency electromagnetic fields as possibly carcinogenic to humans (Group 2B), based on an increased risk of glioma associated with wireless phone use, after a working group of 31 scientists from 14 countries reviewed the evidence.
  • In March 2020, ICNIRP published updated guidelines for 100 kHz to 300 GHz; the local head and torso limit for the general public below 6 GHz remains 2 W/kg over 10 g.

Further reading

Share Facebook X LinkedIn WhatsApp Email

Post a Comment

0 Comments

Your comments will be moderated before it appears here.

Post a Comment (0)

#buttons=(Ok, Go it!) #days=(20)

Our website uses cookies to enhance your experience. Learn more
Ok, Go it!